4
1.0 INSTALLATION
1.1 UNPACKING
Remove the EDA from the shipping carton and inspect for damage. If damage is found, notify the carrier immediate-
ly.
1.2 MOUNTING
The EDA can be pipe, panel, or surface mounted. For pipe mounting thread the unit into a mating female fitting on
the pipe. Use a wrench on the 3/4˝ hex at the base of the housing to tighten the unit to the mating fitting. Do not
thread the unit in by force on the housing. For panel mounting the unit fits into a 4-13/16” (122.24 mm) panel cut out.
Insert the unit into the panel opening and secure in place with the machine screws and adaptors provided with the
unit as shown in Figure 1 below. Maximum panel thickness is 1/8” (3.5 mm) with supplied screws. For surface mount-
ing, panel mount the unit into the A-370 mounting bracket (See the Dwyer catalog or website for ordering details)
also shown in Figure 1. The unit can also be directly surface mounted, as shown in Figure 2, with the proper panel
cutout for the conduit entrances. Support the pressure connection hex with a wrench if attaching a fitting to the unit
in the case of panel or flush mounting so that the pressure connection does not twist. Use a small amount of
plumber’s tape or other suitable sealants to prevent leaks around fitting.
Figure 1: Panel Mounting and Mounting in A-370 Bracket
Figure 2: Surface Mounting
A-370 MOUNTING
BRACKET
EDAW
SEAL
3X MOUNTING
LUG
3X 4-20 X 3/8 SCREWS
3X 6-20 X 2-1/4 SCREWS
3X 4-20 X 3/8
SCREWS
3X ø 1/8 [3.18]
3-1/16
[77.89]
MOUNTING
HOLE DEPTH
3/8 [9.53]
1-5/8
[41.28]
3-15/32 [88.11]
Remote Site Products - 1-888-532-2706 - www.remotesiteproducts.com
http://www.remotesiteproducts.com/p-14328-Dwyer-Mercoid-EDAW-N1E1-06T0-Pressure-Controller.aspx
