P 7
Please retain product label and instructions for future reference
Pre drill
hole
Step 3
Parts Needed - No. 22 QTY 1
No. 32 QTY 1
No. 36 QTY 1
No. 40 QTY 1
No. 41 QTY 1
Place the starter boards (
No. 22, 32, & 40)
on to the assembled base
frame and place the first two log boards
(No.36 & 41)
sitting in the notch as
shown.
Ensure the boards sit square on the base using the same method used in Step
1. Measure from corner to corner and ensure they are equal in
measurement.
Once the boards are square, fix the starter boards
(
No. 22, 32, & 40)
in
place, lift up the log boards
(No.36 & 41)
and fix each starter board in place.
Fix each of the starter boards to the frame by screwing through the notch into
the frame with 1x70mm screw as shown in the illustration.
5x70mm Screws
70mm
screw
IMPORTANT:
Pre-drill before fixing screws.
a
b
40
36
22
41
32
1st
2nd
3rd
5th
4th
36
22
Step 4
Parts needed - No. 25 QTY 1
Make the log cabin level by
adding another board
(No. 25)
as shown in the diagram. Fix
using 1x70mm screw.
**Ensure to stagger the screws
so as not to collide with the
previous screw.
1x70mm Screws
Pre drill
hole
70mm
screw
25
IMPORTANT:
Pre-drill before fixing screws.
Step 5
Parts needed - No. 23 QTY 6
No. 24 QTY 6
No. 33 QTY 6
No. 36 QTY 5
No. 41 QTY 11
Lay the first 6 boards (
No. 23,
24, 33, 36 & 41
) onto the starter
boards to create your first level,
following the method as shown
in the illustrated.
Please note the right hand side
of the door will be slightly
higher. This will even out when
the rest has been assembled.
*Ensure that the boards are
level and flush with each other
as you lay each one.
41
24
23
41
36
33
Rubber Mallet
may be required
to fit parts.
