P 23
Please retain product label and instructions for future reference
1.
IMPORTANT:
Pre-drill before fixing screws.
Step 40
Parts needed - No. 70 QTY 1
Place the floor boards (
No. 70
)
inside the building flush to the log
boards on one side.
Continue adding the floor boards
(
internally
) making sure to interlock
each individual board.
*Do
NOT
secure the boards until
the last board has been measured
and cut.
Following the same method
outlined previously measure the
gap between the bottom of the
tongue (
on the last board placed
)
and the log board.
Using a straight edge mark out the
measurement onto the last floor
board (
No. 70
) and cut along the
length removing the excess.
**Please note:
Mark the final board
2mm under the measurement; This
will allow the timber to expand and
contract correctly.
Once all the floor boards are in
position secure each board into
position using 8x40mm screws per
board.
***Please Note:
Ensure to screw
through each of the floor boards into
the floor bearers.
200x40mm Screws
40mm
screw
Pre drill
hole
This is for illustrative purposes only and may differ from your floor.
70
70
IMPORTANT:
Pre-drill before fixing screws.
Roof
Closure Trim
Internal
67
*Measure and cut the
closure trims to
fit the internal space.
Pre drill
hole
30mm
screw
*
trim to fit
Step 41
Parts needed - No. 67 QTY 7
Inside the building place the closure
trim (
No. 67
) against the boarding and
align with the roof as shown in the
illustration.
*Measure and cut the closure trims to
fit the internal space.
Once in position fix each trim into
place by pre drilling a pilot hole and
using 6x30mm screws per trim,
equally spacing them along the face
of the board.
42x30mm Screws
IMPORTANT:
Pre-drill before fixing screws.
*Internal view
67
67
30mm
screw
Pre drill
hole
*
Cut to fit
Step 42
Parts needed - No. 67 QTY 7
Once the floor has been laid arrange the
closure trim (
No. 67
) around the outside
edge of floor (
internally
), measure and cut
down accordingly to best match the
internal space.
Secure each trim section into place using
6x30mm spaced equally along the board
as shown in the illustration.
*Do NOT fix the closure trim to the floor
boards.
42x30mm Screws
