P 14
Please retain product label and instructions for future reference
40mm
screw
Pre drill
hole
*
Cut to fit
33
33
IMPORTANT:
Pre-drill before fixing screws.
Step 22
Parts Needed - No. 33 QTY 33
Place the first floor board (
No. 33
)
inside the building flush to the log
board on one side. Continue adding
the floor boards (
internally
) making
sure to interlock each individual board.
You have been issued with 31 floor
boards, but in reality you may only
need to use 30.
*Do
NOT
secure the boards until the
last board has been measured and
cut.
Following the same method outlined
previously measure the gap between
the bottom of the tongue (
on the last
board placed
) and the log board.
Using a straight edge mark out the
measurement onto the last floor board
(
No. 33
) and cut along the length
removing the excess.
**Please note:
Mark the final board
2mm under the measurement; This will
allow the timber to expand and contract
correctly.
Once all the floor boards are in posi-
tion secure each board into position
using 8x40mm screws.
***Please Note:
Ensure to screw
through eachof the floor boards into the
floor bearers.
248x40mm Screws
Closure Trim
Internal
23
*Measure and cut the
closure trims to
fit the internal space.
Closure Trim
Internal
35
*Measure and cut the
closure trims to
fit the internal space.
Pre drill
hole
30mm
screw
*
trim to fit
Step 23
Parts needed - No. 35 QTY 7
Inside the building place the closure
trim (
No. 35
) against the boarding and
align with the roof as shown in the
illustration, ensuring the angled face
follows the roof line.
*Measure and cut the closure trims to
fit the internal space.
Once in position fix each trim
into place by pre drilling a pilot hole
and using 6x30mm screws per trim,
equally spacing them along the face
of the board.
48x30mm Screws
Roof
Roof
IMPORTANT:
Pre-drill before fixing screws.
23
23
35
35
30mm
screw
Pre drill
hole
*
Cut to fit
Step 24
Parts needed - No. 35 QTY 7
Once the floor has been laid arrange the
closure trim (
No. 35)
around the outside
edge of floor (
internally
), measure and cut
down accordingly to best match the inter-
nal space.
Secure each trim section into place using
6x30mm spaced equally along the board
as shown in the illustration.
*Do NOT fix the closure trim to the floor-
boards.
48x30mm Screws
IMPORTANT:
Pre-drill before fixing screws.
