‡ Preparations, installation and
taking into operation.
General requirements of the installation site.
Your smart Wallbox Home is an electrical device and is therefore subject to particular requirements for
indoor and outdoor installation. In selecting the installation site, you must consider the following points:
> Observe all local regulations for electrical installations, e.g. regarding fire protection and accident pre-
vention.
> The Wallbox must be installed where it is freely accessible to all authorized
users.
> A parking spot must also be planned for in front of the Wallbox so that the
vehicle's charging connector can at all times be reached with the fixed charging
cable of the Wallbox.
> The recommended installation height is 120 to 140 cm from the floor to the lower
edge of the housing. This recommendation may be adjusted upwards or down-
wards depending on local conditions. Sufficient air circulation must be ensured
at the installation site so that the Wallbox is cooled during operation: Always
observe the allowed operating temperatures (see „Technical specifications.“ on
page 25).
> To ensure the safe operation of the Wallbox, minimum clearances of 50 cm must
be observed on all sides of the housing.
> The mounting area must have an even surface that provides sufficient stability
for installing the Wallbox.
> The required mounting area for the smart Wallbox Home is at least 440 x 330 mm (H x W). The entire rear
surface of the Wallbox must be in contact with the mounting surface.
> In general, the smart Wallbox Home is engineered for operation in high ambient temperatures. However,
it must always be ensured that the maximum operating temperature is not exceeded through external
influences such as direct sunlight or similar.
> The Wallbox meets the requirements for outdoor installation. Outdoors, it is recommended that the Wall-
box is only installed in a covered location that provides sufficient protection from the weather.
Requirements for the power supply cable.
The following standards must always be taken into account for the electrical installation of the smart
Wallbox Home:
> All regulatory requirements for low voltage installations according to IEC 60364-1 and IEC 60364-5-52
apply.
> Model variant A0009066108 is intended for the rated voltage indicated on the product label.
min. 50 cm
120 to
140 cm
03
