Mercedes-Benz S-Class Coupe, Owner'S Manual

Page: 392 / 413

X
To remove: take socket ; and wheel
wrench = from the vehicle tool kit
(
Y
page 355).
X
Position socket ; on hub cap : .
X
Attach wheel wrench = to socket ; and
loosen hub cap : anti-clockwise.
X
Remove hub cap : .
X
To fit: before fitting, check hub cap : and
the wheel area for soiling and clean if nec-
essary.
X
Put hub cap : in position and turn until it is
in the right position.
X
Position socket ; on hub cap : .
X
Attach wheel wrench = to socket ; and
tighten hub cap : .
The tightening torque must be 25 Nm.
i
Note that the hub cap should be tight-
ened to the specified torque of 25 Nm.
Mercedes-Benz recommends that you have
the hub cap fitted at a qualified specialist
workshop.
X
Using wheel wrench = , loosen the bolts on
the wheel you wish to change by about one
full turn. Do not unscrew the bolts com-
pletely.
The jacking points are located just behind the
front wheel arches and just in front of the rear
wheel arches (arrows).
X
Take the ratchet ring spanner out of the
vehicle tool kit and place it on the hexagon
nut of the jack so that the letters AUF are
visible.
X
Position jack A at jacking point ? .
X
Make sure that the base of the jack is posi-
tioned vertically under the jacking point.
Changing a wheel
389
Whe
el
s
and
tyres
Z