Mercedes-Benz Mercedes-AMG GT4-door coupe, Owner'S Manual

Page: 69 / 489

R
Objects or loads in the boot or load com‐
partment cannot be restrained by the
seat backrest.
#
Make sure that the rear bench seat, the
rear seat and the seat backrest are
engaged before every trip.
If the left and right seat backrests are not
engaged and locked in place, this will be shown
on the multifunction display on the instrument
cluster.
If the centre seat backrest is not engaged and
locked in place, the red lock verification indica‐
tor will be visible.
When fitting a belt-secured child restraint
system, observe the following:
O
Always comply with the manufacturer's
installation and operating instructions for
the child restraint system used.
O
For a child restraint system in the "Univer‐
sal" or "Semi-Universal" category, make
sure that the system has been approved for
the vehicle seat.
Observe the notes under "Suitability of
seats for attaching belt-secured child
restraint systems" (
/
page 64).
O When using a weight category 0/0+
baby car seat and a weight category I
rearward-facing child restraint system
on a rear seat: adjust the front seat so that
the seat does not touch the child restraint
system.
O
When using a weight category I forward-
facing child restraint system: remove the
head restraint from the respective seat, if
possible.
After the child restraint system has been
removed, replace the head restraints again
immediately and adjust them correctly.
O The backrest of the forward-facing child
restraint system must, as far as possible, be
resting on the seat backrest of the rear
seat.
O
If the head restraint of the child seat cannot
be fully extended when it is installed in the
vehicle, this will result in restrictions on the
maximum size setting for child restraint sys‐
tems in weight category II or III.
Contact with the roof when the head
restraint is fully extended and locked in
place will not result in any restrictions on
use.
O The child restraint system must not be put
under strain between the roof and the seat
cushion and/or be fitted facing the wrong
direction. Where possible, adjust the seat
cushion inclination accordingly.
O The child restraint system must not be put
under strain by the head restraint. Adjust
the head restraints as appropriate.
O Make sure that the child's feet do not touch
the front seat. If necessary, move the front
seat slightly forwards.
#
Install the child restraint system.
The entire base of the child restraint system
must always rest on the sitting surface of the
rear seat.
#
Always make sure that the shoulder belt
strap is correctly routed from the seat belt
66 Occupant safety