Mercedes-Benz Mercedes-AMG GT4-door coupe, Owner'S Manual

Page: 358 / 489

The tool bag contains:
R
Jack
R
Wheel wrench
R
Centring pin
R
Folding chock
R
Ratchet for jack
Preparing the vehicle for a wheel change
Requirements:
R
The required tyre-change tool kit is available.
If your vehicle is not equipped with the tyre-
change tool kit, consult a qualified specialist
workshop to find out about suitable tools.
R
The vehicle is not on a slope.
R
The vehicle is on solid, non-slippery and level
ground.
#
Apply the electric parking brake manually.
#
Move the front wheels to the straight-ahead
position.
#
Shift the transmission to position j .
#
Switch off the engine.
#
Make sure that the engine cannot be started.
#
Place chocks or other suitable items under
the front and rear of the wheel that is diago‐
nally opposite the wheel you wish to change.
#
Remove the hub caps if necessary
(
/
page 355).
#
Raise the vehicle (
/
page 356).
Removing and fitting the wheel trim/hub
caps
Requirements:
R
The vehicle is prepared for a wheel change
(
/
page 355).
Plastic hub cap
#
To remove: turn the centre cover of the hub
cap anti-clockwise and remove the hub cap.
#
To fit: make sure that the centre cover of the
hub cap is turned anti-clockwise.
#
Position the hub cap and turn the centre
cover clockwise until the hub cap engages
physically and audibly.
Aluminium hub cap
#
To remove: position centring cap 2 from
the tyre-change tool kit on hub cap 1 .
#
Position wheel spanner 3 on centre cap 2 .
Wheels and tyres 355