Charging cable variant 1 (mode 2)
Controls
:
On-board voltage indicator
;
Protective and indicator system display
=
Charge current setting indicator
?
Charge current setting button
When displays
:
and
;
on the charging cable
light up, this means the following:
Indicator
lamp
Signal
:
Lights up green when the sup-
ply voltage is connected. The
high-voltage battery can be
charged.
Flashes red when the power
supply from the building is
faulty.
;
Lights up green if no malfunc-
tions are detected. The high-
voltage battery can be
charged.
Lights up red if residual cur-
rent has been detected or
there is an internal malfunc-
tion. The high-voltage battery
cannot be charged.
If the control detects residual current or a mal-
function, the charging process is halted. Once
the malfunction has been rectified the charging
process is resumed automatically.
For information on problems relating to the
charging process, see (
Y
page 37).
Setting the maximum permissible charge
current
A country-specific maximum charge current is
set for the charging cable. Before starting the
charging process at a power socket, check the
maximum permissible charge current for the
relevant power socket or the building. Observe
the notes on setting the maximum permissible
charge current (
Y
page 34).
X
Insert the mains plug of the charging cable
into the mains socket.
X
Press button
;
repeatedly until the desired
setting is selected in display
:
.
R
Two LEDs are flashing: minimum setting
R
All LEDs are flashing: maximum setting
When you disconnect the charging cable from
the mains socket after charging, the set value is
reset to the minimum setting. You will then need
to reset the value for the maximum charge cur-
rent at the next charging process.
Charging cable variant 2 (mode 2)
Controls
:
Charge current setting indicator
(
Y
page 34)
;
On-board voltage indicator
Charging the high-voltage battery
33
Dr
iv
ing
and
pa
rk
ing
Z
