Diesel engines with a
diesel particle filter
MB-Freigabe or
MB-Approval
GLA 180 d
226.51, 229.31,
229.51, 229.52
All other models
228.51, 229.31,
229.51, 229.52
Diesel engines without a
diesel particle filter
MB-Freigabe or
MB-Approval
All models
Use only SAE 0W-40 or SAE 5W-40 engine oils
for Mercedes-AMG vehicles.
i
If the engine oils listed in the table are not
available, you may add the following engine
oils until the next engine oil change:
R
Petrol engines: MB-Freigabe or MB-
Approval 229.3 or ACEA A3/B3
R
Diesel engines: MB-Freigabe or MB-
Approval 229.3, 229.5 or ACEA C3
It may be used only once and the topping-up
quantity must not exceed 1.0 l.
Filling capacities
The following values refer to an engine oil
change, including the oil filter.
Model
Replacement
amount
GLA 180
GLA 200
5.8 l
GLA 180 d
4.5 l
GLA 220
GLA 250
GLA 250 4MATIC
5.6 l
Mercedes
‑
AMG GLA 45
4MATIC
5.5 l
All other models
6.5 l
Additives
!
Do not use any additives with the engine oil.
This could damage the engine.
Brake fluid
G
WARNING
The brake fluid continuously absorbs mois-
ture from the air. This results in the boiling
point of the brake fluid lowering. If the boiling
point of the brake fluid is too low, vapour
pockets may form when the brakes are sub-
jected to a heavy load. This would impair brak-
ing efficiency. There is a risk of an accident.
Have the brake fluid renewed at the prescri-
bed intervals.
When handling brake fluid, observe the impor-
tant safety notes on service products
(
Y
page 352).
The brake fluid change intervals can be found in
the Service Booklet.
Only use brake fluid approved by Mercedes-
Benz according to MB-Freigabe or MB-Approval
331.0.
Information about approved brake fluid can be
obtained at any qualified specialist workshop or
on the Internet at
http://bevo.mercedes-benz.com.
i
Have the brake fluid regularly replaced at a
qualified specialist workshop and the replace-
ment confirmed in the Service Booklet.
Coolant
Important safety notes
G
WARNING
If antifreeze comes into contact with hot com-
ponents in the engine compartment, it may
ignite. There is a risk of fire and injury.
Let the engine cool down before you top up
the antifreeze. Make sure that antifreeze is
not spilled next to the filler neck. Thoroughly
clean the antifreeze from components before
starting the engine.
!
Only add coolant that has been premixed
with the desired antifreeze protection. You
could otherwise damage the engine.
Further information on coolants can be found
in the Mercedes-Benz Specifications for Ser-
vice Products, MB Specifications for Service
356
Service products and capacities
Tec
hni
cal
data
