#
Take care to only connect battery termi-
nals of identical polarity when receiving
starting assistance.
#
Observe the sequence described for
connecting and disconnecting the jump
leads when receiving starting assistance.
#
Do not connect or disconnect the bat-
tery terminals while the engine is run-
ning.
&
W
WARNING
ARNING Risk of explosion due to explo-
sive mixture of gases
An explosive mixture of gases can escape
from the battery during charging and starting
assistance.
#
Fire, naked ames, smoking and creating
sparks must be avoided.
#
Make sure there is adequate ventilation.
#
Do not stand over the battery.
&
W
WARNING
ARNING Risk of explosion from a frozen
battery
A discharged battery may freeze at tempera-
tures slightly above or below freezing point.
During starting assistance or battery charging,
battery gas can be released.
#
Always allow a battery to thaw before
charging it or performing starting assis-
tance.
If the indicator/warning lamps in the instrument
cluster do not light up at low temperatures, it is
very likely that the discharged battery has frozen.
In this case you may neither jump-start the vehi-
cle nor charge the battery.
The service life of a battery that has been thawed
may be dramatically shortened. The starting char-
acteristics may be impaired, especially at low
temperatures.
It is recommended that you have a thawed battery
checked at a quali ed specialist workshop.
Plug-in h
Plug-in hybr
ybrid
id
If your vehicle has been started with starting
assistance, it may not be possible to use the elec-
tric drive for approximately 30 minutes.
Starting assistance is not considered to be a nor-
mal operating condition.
All v
All vehicles
ehicles
*
NO
NOTE
TE Damage caused by numerous or
extended attempts to start the engine
Numerous or extended attempts to start the
engine may damage the catalytic converter
due to non-combusted fuel.
#
Avoid numerous and extended attempts
to start the engine.
Observe the following points during starting assis-
tance and when charging the battery:
R
Only use undamaged jump lead/charging
cables with a su cient cross-section and
insulated terminal clamps.
R
Non-insulated parts of the terminal clamps
must not come into contact with other metal
Breakdown assistance 353
353
Summary of Contents for CLA
