Resetting the panorama roof with
power tilt/sliding panel and the roller
sunblinds
Reset the panorama roof with power tilt/
sliding panel and the roller sunblinds if the
panorama roof with power tilt/sliding panel
or the roller sunblind do not open smoothly.
!
Do not open the panorama sliding sunroof
until it has been reset properly. Otherwise,
the panorama roof with power tilt/sliding
panel may lock in the open position.
If the panorama roof with power tilt/sliding
panel cannot be closed or adjusted,
contact a qualified specialist workshop,
e.g. a Mercedes-Benz Service Center.
X
Turn the key to position
2 in the ignition
lock.
X
Press the
3
switch to the point of
resistance in the direction of arrow
;
and
hold it until the roller sunblinds are fully
open.
X
Press the
3
switch to the point of
resistance in the direction of arrow
;
and
hold it until the panorama roof with power
tilt/sliding panel has opened about 10 cm.
X
Pull the
3
switch repeatedly to the point
of resistance in the direction of arrow
=
until the panorama roof with power tilt/
sliding panel is fully closed.
X
Keep the
3
switch pulled for an
additional second.
X
Pull the
3
switch to the point of
resistance in the direction of arrow
=
and
hold it until the roller sunblinds are fully
closed.
X
Keep the
3
switch pulled for an
additional second.
X
Make sure that the panorama roof with
power tilt/sliding panel can be opened fully
again (
X
If this is not the case, the previously
described steps must be repeated or you
should consult a qualified specialist
workshop.
Problems with the sliding sunroof
Problem: the sunroof cannot be closed
and you cannot see the cause.
You could be severely or even fatally injured
when closing the sliding sunroof with
increased closing force or if the anti-
entrapment feature is deactivated. Make sure
that nobody can become trapped when
closing the sliding sunroof.
If the sliding sunroof is obstructed during
closing:
X
Immediately after the sliding sunroof
blocks, pull the
3
switch in the
overhead control panel down to the point
of resistance and hold it until the sliding
sunroof is closed.
The sliding sunroof is closed with increased
force.
If the sliding sunroof is obstructed during
closing again:
X
Immediately after the sliding sunroof
blocks, pull the
3
switch in the
overhead control panel down to the point
of resistance and hold it until the sliding
sunroof is closed.
The sliding sunroof is closed without the
anti-entrapment feature.
Pressing and holding the sliding sunroof
switch to close the sliding sunroof
immediately after it had been blocked two
times will cause the sliding sunroof to close
without the anti-entrapment feature for as
long as you hold the switch.
90
Sliding sunroof
Opening and closing
BA 204 USA, CA Edition A 2011; 1; 5, en-US
hereepe
Version: 3.0.3.6
2010-05-20T09:17:30+02:00 - Seite 90
