X
Push latch plate
;
into buckle
=
until it
clicks.
X
If necessary, adjust the seat belt to the
correct height (
Y
page 51).
X
If necessary, tighten the lap portion to a
snug fit by pulling shoulder portion up.
All lap/shoulder belts except the driver’s seat
belt have special seat belt retractors to
secure child restraints properly. For more
information on special seat belt retractors,
see “Infant and child restraint systems”
(
Y
page 55).
To release the seat belt with seat belt release
button
?
, see (
Y
page 51).
Seat belt outlet height adjustment
You can adjust the height of the seat belt
outlet for the driver’s and front passenger
seat.
X
Raising: Slide the seat belt outlet height
adjuster upward.
The seat belt outlet height adjuster
engages in different positions.
X
Lowering: Press and hold release
button
:
.
X
Slide the seat belt outlet height adjuster
downward.
X
Release release button
:
and make sure
the seat belt outlet height adjuster engages
into place.
Releasing the seat belts
X
Press seat belt release button
?
(
Y
page 50).
Allow the retractor to completely rewind
the seat belt by guiding latch plate
;
(
Y
page 50).
!
Make sure the seat belt retracts
completely. Otherwise the seat belt and/or
latch plate could get caught or pinched in
the door or in the seat mechanism. This can
damage the seat belt and impair its
effectiveness, and/or cause damage to the
door and/or door trim panel. Such damage
is not covered by the Mercedes-Benz
Limited Warranty.
Damaged seat belts must be replaced.
Contact an authorized Mercedes-Benz
Center.
Enhanced seat belt reminder system
When the engine is started, the seat belt
telltale
7
will always illuminate for
6 seconds to remind you and your passengers
to fasten your seat belts.
If the driver’s seat belt is not fastened when
the engine is started, an additional warning
chime will sound. The warning chime goes out
after approximately 6 seconds or once the
driver’s seat belt is fastened.
If after these 6 seconds the driver’s or the
front passenger’s seat belt (with the front
passenger seat occupied) is not fastened with
front doors closed,
R
the seat belt telltale
7
remains
illuminated for as long as either the driver’s
or front passenger’s seat belt is not
fastened.
R
and if the vehicle speed once exceeds
15 mph (25 km/h), the seat belt telltale
7
starts flashing and a warning chime
sounds with increasing intensity for a
maximum of 60 seconds or until the
driver’s and front passenger’s seat belt are
fastened.
Occupant safety
51
Safety and security
204_AKB; 5; 23, en-US
d2ureepe,
Version: 2.11.8.1
2009-07-16T17:54:06+02:00 - Seite 51
Z
Summary of Contents for 2010 C 250
