Mercedes-Benz 2005 C 230 Kompressor, Operator'S Manual

Page: 279 / 482

277
Controls in detail
Useful features
Step 3:
왘
Hold the end of the hand-held remote
control transmitter
6 of the device
you wish to train approximately 2 to
5 in (5 to12 cm) away from the surface
of the integrated remote control
located on the interior rear view mirror,
keeping the indicator lamp
1 in view.
Step 4:
왘
Using both hands, simultaneously
press the hand-held transmitter
button
5 and the desired integrated
signal transmitter button ( 2 , 3
or 4 ). Do not release the buttons until
completing step 5.
The indicator lamp 1 on the
integrated remote control will flash,
first slowly and then rapidly.
Step 5:
왘
When the indicator lamp 1 flashes
rapidly, release both buttons.
Step 6:
왘
Press and hold the just-trained
integrated signal transmitter button
and observe the indicator lamp
1 .
If the indicator lamp 1 stays on
constantly, programming is complete
and your device should activate when
the integrated signal transmitter
button is pressed and released.
Step 7:
왘
To program the remaining two buttons,
repeat the steps above starting with
step 3.
i
The indicator lamp 1 flashes the first
time the signal transmitter button is
programmed. If this button has already
been programmed, the indicator lamp
will only start flashing after
20 seconds.
i
If the indicator lamp 1 flashes rapidly
for about two seconds and then turns
to a constant light, continue with
programming steps 8 through 12 as
your garage door opener may be
equipped with the “rolling code”
feature.