Mercedes-Benz 2004 C-Class Wagon, Operator'S Manual

Page: 48 / 400

48
Getting started
Driving
Single wipe
왘
Press combination switch briefly in
direction of arrow
1 .
The windshield wipers wipe one time
without washer fluid.
Wiping with windshield washer fluid
왘
Push combination switch in direction of
arrow
1 past the resistance point.
The windshield wipers operate with
washer fluid.
For information on filling up the washer
reservoir, see “Windshield washer system
and headlamp cleaning system*”
(
컄
page 259).
!
Vehicles with rain sensor*:
Do not leave windshield wipers in inter-
mittent setting when the vehicle is tak-
en to an automatic car wash or during
windshield cleaning. Wipers will oper-
ate in the presence of water sprayed on
the windshield, and wipers may be
damaged as a result.
The switch should not be left in inter-
mittent setting as the wipers will wipe
the windshield once every time the en-
gine is started. Dust that accumulates
on the windshield might scratch the
glass and/or damage the wiper blades
when wiping occurs on a dry wind-
shield.
!
If anything blocks the windshield
wipers (leaves, snow, etc.), switch
them off immediately.
앫 For safety reasons, withdraw
SmartKey from starter switch
before attempting to remove any
blockage.
앫
Remove blockage.
앫 Turn the windshield wipers on
again.
If windshield wipers fail to function at
all in switch position
I ,
앫 set the combination switch to the
next highest wiper speed
앫
have the windshield wipers
checked at the nearest authorized
Mercedes-Benz Center