10
Instructions for use for medical work chairs in the REAL 9000 PLUS device range
Getting started
21-08742-EN-01
How to charge the device
1. Connect the charger plug into the
charging socket, see Figure 2.5. The
charging socket is normally located at the
rear edge of the left armrest, but can also
be located under the seat, for example.
2. Connect the charger plug into the wall
socket. The LED on the charger will
indicate that charging is underway.
3. The battery is fully charged when the
LED on the charger changes colour from
red to green. If you are using the hand-
held controller, this will also be indicated
by the three green battery LEDs on the
controller, which will start to flash at the
same time.
If the electrical functions have not been
used for 7 days, the battery switches off
automatically. To reconnect the battery,
connect the battery charger to the charging
socket and the wall outlet and wait at least 5
seconds before unplugging the charger. It is
recommended to charge the battery fully
after the battery has been disconnected.
If no electrical functions are working, try
charging the battery. If electrical functions
still do not work, contact your prescriber or
distributor, see 1.1. Contact details.
2.4. Transfers
When moving around while sitting in the
device, it is important to make good contact
with the floor. For example, rubber-soled
indoor shoes can provide better grip and
thus facilitate movement. If the device is
equipped with seat tilt, and if you have
the physical balance to adjust the seat tilt
forward slightly, then this can also provide
better grip on the floor. A slightly forward-
leaning seating position also gives more
power in the movement. Rugs and carpets
make the movement more difficult. It is
therefore recommended to remove rugs or
carpets if you want to move while sitting.
When moving across different surfaces,
you get more power if you move backwards
over thresholds, mouldings and gaps. Lower
the seat and, if possible, adjust the seat tilt
forward slightly to get over the threshold.
Warning! Always ensure that the
device’s brake is applied when
sitting down and getting up. If the
device is not braked, it risks rolling
away when you get up or sit down,
which can lead to fall injuries.
Figure 2.5. Connecting the plug to the charging socket
under the armrest.
Summary of Contents for REAL 9000 PLUS Series
Page 2: ...Space for device label with serial number...
Page 60: ......
