Menzer ETS 150 2.5, Translation Of The Original Operating Manual

Page: 32 / 92

12 EN
ENGLISH
Problem possible causes remediation
• The machine is
without function or
malfunctioning.
• Mains plug is incorrectly inserted
into the mains socket.
• Mains plug is defective.
• Mains fuse was tripped.
• Check the plug connection; insert
the mains plug correctly into the
mains socket.
• Check the mains fuse.
• Contact the MENZER repair service.
• The machine is
too noisy.
• Machine vibration
is excessive.
• The driving disc or abrasive is not
attached correctly.
• The material or substrate to be
processed is too hard.
• Attach the driving disc and abrasive
securely and centrically.
• Change the rotational speed.
• Choose another abrasive. Read our
abrasive overviews or seek advice.
• Contact the MENZER repair service.
• The machine
produces too much
dust.
• Insufficient
extraction perfor-
mance.
• Clogged extraction system.
• Dust bag in the industrial extractor
is full.
• Kink in the extractor hose.
• The extraction openings in the
driving disc and sanding disc are not
congruent.
• Clean the extraction system.
• Empty the dust bag.
• Remove the kink.
• Position the extraction openings
congruently.
• Too much of
the substrate is
abraded.
• The grit size of the abrasive is too
large.
• Choose a smaller grit size.
• The entire sand -
ing area displays a
bad or sub-optimal
surface quality.
• The abrasive grit is incorrect or too
large and/or the incorrect type of
abrasive is being used.
• The material or substrate to be pro -
cessed is not yet completely dry.
• The material or substrate to be
processed is too soft and/or has a very
high filler content.
• Choose a smaller grit size and/or a
different type of abrasive. Read our
abrasive overviews or seek advice.
• Read the data sheets and processing
instructions provided by the manufac-
turer of the material to be processed.
• Striae in the
sanded area.
• Driving disc not flat on the substrate.
• The material or substrate to be
processed is too soft.
• Position the driving disc flat on the
substrate.
• Choose a smaller grit size.
• Deteriorating
adhesion of
the abrasive or
the driving disc
accessory.
• Reverse of the abrasive is worn.
• Hook & loop layer on the driving disc
is worn.
• Replace the abrasive.
• Replace the driving disc.
• Use MENZER pad saver.
7. Error handling and troubleshooting