85-03-01145
ML54
Page
17
ML54 Fireplace Ratings Information
This Mendota Fireplace can be installed directly on top of a metal, masonry or wood structural surface.
ELECTRICAL REQUIREMENTS
: 120 Volts AC, 3.5 Amps (minimum line voltage allowed 110 Volts AC) REQUIRED
GAS SUPPLY PRESSURE
:
NAT. GAS: 7" W.C. [5.0" W.C. MIN., 11" W.C. MAX.]
L.P. GAS: 11" W.C. [11" W.C. MIN., 13" W.C. MAX.]
LP GAS CONVERSION KIT
: This Fireplace comes configured for use with Natural Gas. To convert the Fireplace for use with LP
Gas, install: LP GAS CONVERSION KIT #HA-90-00110.
GAS INPUT RATES
High Fire
Low Fire
BTUH .......................... NAT. GAS
41,000
27,500
BTUH .......................... L.P. GAS
41,000
33,000
ORIFICE SIZES
…………
[0-2000ft (610 m)]:
1/8” NG [#49 L.P.]
[2000-4500ft (610-1370 m)]:
1/8” NG [#49 L.P.]
P.4 FIREPLACE EFFICIENCY
.......... 70%
FLUE VENTING
............COAXIAL RIGID- 5
” DIAMETER EXHAUST &
8
” DIAMETER
AIR INLET AND APPROVED VENT CAPS
APPROVED FOR USE WITH MENDOTA POWER VET KITS AA-11-04071, AA-11-04072, and AA-11-04100.
All UL Listed Coaxial Rigid 5”X8” Vent pipe components and vent caps are approved for use. Do not mix
components of
different brands or series. Always use the same brand and series components throughout the entire vent system.
MINIMUM CLEARANCES TO COMBUSTIBLE CONSTRUCTION
UNIT TO FLOOR
0in. (0mm)
UNIT SIDE TO ADJACENT SIDEWALL 18in. (457 mm)
UNIT TO ENCLOSURE SIDEWALL
1/2in. (13mm)
VENT PIPE TOP TO COMBUSTIBLES
3in. (76mm)
UNIT TO ENCLOSURE BACK WALL
1/2in. (13mm)
VENT PIPE SIDES TO COMBUSTIBLES
1in. (25mm)
UNIT BOTTOM TO ENCLOSURE CEILING 64 1/4 in. (163cm) VENT PIPE BOTTOM TO COMBUSTIBLES 1in. (25mm)
UNIT BOTTOM TO ROOM CEILING
72 in. (1829 mm)
DISTANCE TO
8” MANTLE ABOVE TOP CONVECTION AIR DISCHARGE OPENING
20 in. (508 mm)
MINIMUM COMBUSTIBLE ROUGH FRAMING DIMENSIONS
WIDTH = 62
” (
158cm)
HEIGHT = 44
” (1
12cm)
DEPTH = 19.5
” (5
0cm)
NET WEIGHT
................350 lbs. (Team Lift recommended)
BARRIER SCREEN
: A barrier screen that has been certified for use with this Fireplace must be installed on the Fireplace when it
is in use. The barrier screen will prevent accidental contact with the glass door face, which could result in a severe burn.
SAFETY
: AGA certified, electronic ignition IPI system activated with thermostatic remote control.
CERTIFIED TO
: ANSI Z21.88/CSA 2.33
This Mendota Gas Fireplace has been tested and certified by:
Intertek Testing Services, 8431 Murphy Drive, Middleton, WI 53562
ICBO#AA647-4
ADDITIONAL OPTIONS
This fireplace is available with a variety of different log and media sets, decorative fronts, interior panels, and underlighting.
Consult your Mendota dealer for more information about these options.
