85-03-01205
ML-SERIES FIREPLACE
Page
72
5.4
OPERATING INFORMATION
5.4.1
Using Your Remote Control
Your Mendota remote control is pre-programmed to your fireplace. Ensure you have installed 3 AAA batteries into your remote.
Press the top button on the remote control. If you do not hear a beep when you pr ess this button, follow the instructions below
to synchronize your fireplace and remote control.
5.4.2
Synchronizing the Fireplace and Remote Control
Mast e r Sw it ch
”
The maste r switc h ac ts as the main safe ty on/off c ontr ol for the main gas bur ne r s only.
W he n the maste r switc h is in the off -c ondition, the main gas bur ne r s will not tur n on. Howe ve r , all othe r
fir e plac e func tions, inc luding the standing pilot mode , will ope r ate . W he n the maste r switc h is in the on -
c ondition, the main bur ne r s will func tion as de signe d .
I n case of an e m e r ge ncy, t oggle t he m ast e r sw it ch t o off t o t ur n off t he m ain bur ne r s.
To synchronize the fireplace and remote control, follow the steps below:
1.
Toggle the
master switch
to “
ON
”.
Switch is in the ON position when pointing to the left, as shown in the diagram below.
2.
Locate
sync switch
(see diagram below). Press the sync button and release. The fireplace will
beep three
times
indicating
that it is ready to synchronize with a remote control. (Note: If you do not hear any beeps when you press the sync button,
contact your Mendota dealer or installer for assistance.)
3.
Within seven
seconds, press the “on”
button on the remote control. The fireplace will
beep four
times
to indicate that the
remote control
’s command
is accepted and sets to the particular code of that controller.
Your system is now initialized.
