85-03-01060-D
FV44i Décor Gen 3
Page
60
9.
Locate Pilot Light on left side of firebox between the two air shutter
boxes.
While holding the pilot base body with large vice grips
tightly
, loosen pilot light hood using a 7/16
” open end
wrench on
the hex shaped base. Rotate counter clock-wise ¼ turn to loosen.
DO NOT REMOVE THE PILOT HOOD, ONLY LOOSEN.
10.
Pilot arrives from the factory set for NG. Push NG/LP adjustment clip
inward
all the way to set it for LP. If you see “NAT” printing on
the
adjustment clip, this indicates that the pilot is set to burn NG. Push
clip i
n so that “NAT” is not visible.
11.
Tighten down hex shaped base of pilot using a 7/16
” open end
wrench.
CAUTION: Always
use one 7/16” open end wrench and one large
pliers or vice grips tool to hold, loosen and tighten pilot hood
base to prevent damage to pilot mount bracket.
Figure 4-14 Pinch Pilot Base with Vice
Grips
Figure 4-15 Pilot Body
Figure 4-16 Pilot Orifice Selection
7/16”
HEX
Adjustment
clip
