41
5.
Using a ½” deep well socket wrench, remove Front and Rear Orifices.
6.
Thread a new 3/64” drilled orifice to both Front and Rear Orifice mounting brass fittings. Tighten down orifices.
7.
Remove the left-side access panel mounted to the left outer skin and lay down gently without disconnecting any wires of
internal components.
8. Locate Pilot Light on right side of firebox. While hold-
ing the pilot base body with large vice grips tightly, loosen Pilot Light’s hex shape base using a ½” open
end wrench. Rotate counter clock-wise ¼ turn to loosen.
9. Pilot arrives from the factory set for NG. Push NG/LP Adjustment Clip inward all the way to set it for LP.
See detail view, below. If you see “NAT” printing on the Adjustment Clip, this indicates that the pilot is set
to burn NG. Push Clip in so that “NAT” is not visible.
10. Tighten down Hex shaped base of pilot using a ½” open end wrench.
FRONT
ORIFICE
REAR
ORIFICE
DETAIL D
DETAIL C
REAR
BURNER
PILOT LIGHT
HOOD
FRONT
BURNER
