85-03-00955
P a g e
|
67
WARNING:
It is of the utmost importance that the correct burner orifice be installed
Turn off gas supply at the appliance service valve.
See written instructions that accompany the LP pressure regulator.
1. Using a Torx T20 or a slotted screwdriver, remove 2 screws that secure the NG Pressure Regulator to the gas valve
body and remove NG Pressure Regulator, see following page.
2. Install the new LP Pressure Regular onto the gas valve body in the same position and orientation as the NG Pressure
Regulator you removed in Step 3, above. The LP Pressure Regulator can only be mounted in one position. Secure the
LP Pressure Regulator in place. Tighten down.
3. Remove the Burner. Locate and Identify the Burner Orifice Spud. The Orifice Spud can be removed and installed using
a ½” hex wrench.
4.
WARNING
: Make certain to Secure the Brass fitting and flex supply tube attached to the orifice in place using a 1/2"
open end wrench before attempting to remove the burner orifice and also when installing and tightening the new LP
orifice.
5. Install Burner Orifice #65-14-00050 (#50 drill) for the Main Burner. Tighten down securely.
6. Loosen Pilot Light’s hex shape base using a 7/16” open end wrench. Rotate counter clock-wise ¼ turn to loosen.
7. Pilot arrives from the factory set for NG. Push NG/LP Adjustment Clip inward all the way to set it for LP. See detail view,
below. If you see “NAT” printing on the Adjustment Clip, this indicates that the pilot is set to burn NG. Push Clip in so
that “NAT” is not visible.
8. Tighten down Hex shaped base of pilot using a ½” open end wrench.
Burner Orifice
[#50]
Motorized
LP Pressure
Regulator
[10.0-5.5"WC]
