Rev 1.2
Mellanox Technologies
43
4.2.1.3 Power Supply Status LEDs
Figure 27: Power Status LED
There are two power supply inlets in the system (for redundancy). The system can operate with
only one power supply connected. In case the power supply is an FRU, a second power supply
unit can be added to support hot-swap ability. Each power supply unit has a single 2 color LED
on the right side of the unit, that indicates the status of the unit.
Figure 28: Rear Side Panel
The primary power supply (PS) unit is located on the left side and the secondary unit is located
on the right side.
Table 16 - Power Supply Unit Status Front LED Assignments
LED Behavior
Description
Action Required
Solid Green
All plugged (one or two) power supplies are
running normally.
N/A
Solid Red
One or both of the power supplies are not
operational or not powered up/ the AC power
cable is disconnected
Make sure the AC cable is plugged in
and active. If the problem resumes, the
FRUs might be faulty, and should then
be replaced.
Off
N/A
N/A
Summary of Contents for SB7700
