Basic Operation and Installation
Rev 1.5
Mellanox Technologies
36
Figure 24: Fan Module Latches
To insert a FAN Unit:
1. Make sure the mating connector of the new unit is free of any dirt and/or obstacles.
2. Insert the fan unit by sliding it into the opening until slight resistance is felt. Continue press-
ing the fan unit until it seats completely.
The green fan status indicator should light. If not, extract the fan unit and reinsert it.
After two unsuccessful attempts to install the fan unit, power off the switch before
attempting any system debug.
OK
Mellanox
OK
These two latches must be pushed towards each other at the
same time while the module is pulled out.
