ConnectX EN Dual Port Ethernet Network Interface Cards With PCI Express x8 User’s Manual
31
Rev 0.30
Mellanox Technologies
C.2 Placing a Kapton
®
Polyimide Label
Prior to assembling the bracket, you need to apply a Kapton
®
polyimide round label on the board’s Print Side.
Note: Check to see if the label is already installed as this label may have been installed at the factory.
Note: The label can be provided by Mellanox Technologies (P/N: MEC000821).
The following steps are instructions for placing the polyimide label:
1.
Make sure your working area is ESD protected.
2. Hold the label with light pincers. See Figure 12.
Figure 11: Rotate the Bracket to Detach it From the Card
(a) Card without Clips and Screws
(b) Grip the Card in preparation for Detachment
(c) Rotate the bracket toward the Component Side.
Figure 12: Hold Kapton Label With Pincers