INTRODUCTION
To get the best out of your fan, please read these instructions
carefully before using it for the first time.
We also recommend that you keep the instructions for future
reference, so that you can remind yourself of the functions of the
fan.
IMPORTANT SAFETY MEASURES
•
Please ensure that the voltage of the fan corresponds to the
mains voltage.
•
Use the fan only for the purpose(s) defined in the user guide.
•
Never insert your fingers, pencils or other objects through the
cage during operation.
•
Switch the fan off before moving or cleaning it.
•
The fan should be set up on a stable and level surface to
avoid it being knocked over.
•
Do not expose the fan to excessive heat or humidity, as this
can cause damage to the electrical components.
•
Do not immerse in any form of liquid.
•
It is not advisable to expose people, in particular babies and
the elderly, to a continuous stream of cold air.
•
The fan should be kept out of the reach of children.
•
Ensure that the cable does not get caught beneath the device,
in drawers, behind shelves etc.
•
Do not run the cable under carpets, rugs, etc.
•
Ensure the cable is kept away from busy areas to avoid
anyone tripping over it.
•
Do not use if the device or cable becomes damaged. Take it
to a specialist for repair.
•
For indoor use only.
OVERVIEW OF FUNCTIONS
Fan:
1. Fan motor assembly
2. Rear
grille
3. Grille
retaining
ring
4. Motor
spindle
5. Blade
6. Blade
retaining
knob
7. Front
grille
8. Grille
retaining
Clips
9.
Head clamping screw
10. Control panel
11. Height adjustment ring
12. Fastening screw
13. Stand
14. Base feet
15. Base cap
Operating panel:
16. Receiver for remote control signal
17. Power on indicator
18. Swing button
19. Swing indicator
20. Mode button
21. On and speed button
22. Speed indicators (High, Mid, Low)
23. Mode indicators (Nature, Sleep)
24. Timer button
25. Timer indicators (0.5h, 1h, 2h, 4h)
26. Off button
Remote control:
27. Signal for fan
28. Swing button
29. Timer button
30. Mode button
31. Off button
32. On and speed button
FITTING:
•
Place the 2 base feet so they form
a cross and attach the stand to
the base feet using the 4 screws.
•
Place the base cap so it covers
the 4 screws.
•
Loosen the height adjustment
ring.
•
Slide out the stand to the desired
height and tighten the height
adjustment ring firmly.
CAUTION: The height adjustment
ring must be fully tightened before
the assembly of the motor section to
the stand.
•
Attach the motor/body assembly
to the top of the stand and tighten
the fastening screw firmly.
•
Unscrew the blade retaining knob
from the motor spindle by rotating
it clockwise.
•
Unscrew the grille retaining ring
from the front of the motor
housing by rotating it anti-
clockwise.
10
UK
11.
10.
14.
15.
1.
9.
13.
16.
17.
18.
19.
20.
21.
24.
26.
22.
23.
25.
27.
28.
30.
32.
29.
31.
2.
3.
4.
5.
6.
7.
8.
12.
FS40G_IM6 13/02/06 9:08 Side 10
