35
UK
TROUBLESHOOTING
Problem
Possible cause
Possible solution
The conveyor (7) is
stuck out of the start
position.
The appliance is
switched off or there
has been a power cut.
Remove the plug from the socket
and carefully push the conveyor
back to the start position. Remove
any ice stuck on or around the
conveyor.
TheICE indicator
comes on, but the
conveyor does not
push the ice cubes
into the ice bucket.
urven.
Check that the water
tray (6) is completely
horizontal.
Remove the plug from the socket
and carefully position the water tray
horizontally by gently pushing it
towards the conveyor.
The ADD WATER
indicator comes on.
1. The tank is empty.
2. There is air in the
pump system.
1. Switch off the appliance, refill
the water and wait 3 minutes be-
fore turning the appliance back
on.
2. Pull the front of the appliance
6 mm over the table edge and
hold a bowl under the appliance.
Remove the drain plug (13) from
the water tank and reinsert it
once a little water has run out.
The ice cubes are
so big that they are
freezing together.
1. There is ice from
previous cycles in
the water tray, or
the water in the
tank is too cold.
2. The evaporator is
too low.
1. Switch off the appliance and al-
low the ice to melt before restart-
ing the appliance.
2. Carefully pull the evaporator up
slightly.
The ICE FULL
indicator comes on
but the ice basket is
not full.
The light receiver
and/or light emitter is
dirty.
Wipe the light receiver and light
emitter.
Water is running out
of the front of the ap-
pliance.
The drain plug is not
correctly positioned.
Screw the drain plug correctly into
the hole in the bottom of the water
tank.