INSTALLATION
3-3
MA-5151-ENG
PATTERN CONTROLLER STARBI
Warning:
Connect to a 100-240V ±10% and 50/60 Hz alternating current
source with ground connection.
The power connection and protection fuse (2 or 3.15 A, depending on the
model) are located on the rear of the unit. Before making the connection:
- Make sure that the characteristics of the network match the
specifications of the device (see data in this manual and on the
nameplate).
- StarBi 4-6 Outputs: Use the mounting flange of the power connector
(supplied with the controller) to avoid false contact problems and the
malfunctioning of the unit.
- StarBi 2 Outputs: Pass the connection cable through the corresponding
PG cable gland and connect it to the power terminal inside the unit.
Furthermore, the supply cable of the equipment must have an
accessible external disconnection device.
- Connect the other end of the cable to the corresponding socket
(according to the regulations of each country) or to the connection
terminals of the main machine.
- In the event of any failure starting the unit, check the fuse, unscrewing
the lid that protects it a quarter of a turn. If it has blown, replace it with
another of the same value.
- Connect the peripheral components (applicators, photocells, encoder,
0-10 V signal cable and/or applicator inhibit signal cable) with their
corresponding connectors.
- Firmly screw the fixing nuts of the connectors. The connections are
designed with the Poka-Yoke (error-proofing) system in the 4 and 6
channel versions to ensure that each peripheral is connected in the
right place.
Protective fuse
StarBi 2 outputs: 2A FF 6.3x32
StarBi 4/6 outputs: 3.15A FF 6.3x32