26
6.3.4 Printing
out
all stored cycles ___________________________________________________________
If you have connected an external printer to the autoclave, and if you have initialised this printer, you can print out
all stored logs at any point in time. To do this, switch on the autoclave at its mains power switch, and make the
following settings:
Operator action
Shown on the display:
1. Press the "+" button and hold
it down; while holding it down,
press the "–" button. The
menu item “Function” with
sub-menu “Print” will appear.
2. Press the button "Program".
The menu item "Print" with
sub-menu "File transmission"
will appear.
3. Press the button "+" (or "-" )
repeatedly until the following
sub-menu appears in the
display: "Print storaged cy-
cles".
4. Press the button "Program" to
print out all stored cycles (up
to 40). You can press "Start-
Stop" to cancel printing, but
once the printout has started,
you can interrupt it only by
switching off the main power
switch.
5. After the printout is finished,
the initial message appears
again:
6. Press "Start-Stop" to return to
the menu "Function".
7. Then press "Start-Stop" again
to return to the initial menu
position.
Program Start-Stop
F u n c t i o n :
P r i n t
Program Start-Stop
F u n c t i o n :
P r i n t
Program Start-Stop
1 4 : 2 7 : 1 2
0 . 0 2 b a r 2 5 ° C
Program Start-Stop
P r i n t
F i l e t r a n s m i s s i o n
Program Start-Stop
P r i n t s t o r a g e d
c y c l e s
Program Start-Stop
P r i n t s t o r a g e d
c y c l e s
Program Start-Stop
P r i n t o u t