Chapter 4 – Settings
12
Changing the sealing temperature
To alter the set sealing temperature proceed as follows:
1.
Hold the two keys
and
depressed for approx. 2 seconds until two arrows
appear on
the right edge of the display.
2.
Holding one of the arrows depressed initiates the temperature display. The temperature ranges
from 100 °C until 199 °C.
3.
Release the key when the desired sealing temperature has been reached.
Temperature too high
If the device has been switched on for a while and had already reached the previously set temperature, the
display will switch to
Cooling
if the newly-set sealing temperature is lower than that already set.
Temperature too low
If the device has been switched on for a while and had already reached the previously set temperature, the
display will switch to
Heating up
if the newly-set sealing temperature is higher than that already set.
The sealing temperature set is saved, even after the sealing device has been switched off.
Setting the Signal tone
It is possible to set a signal tone to control the number of packages to be sealed. It will sound after the pre-
set number of seals has been completed. This function is useful when needing to seal a larger quantity of
packages.
To set the counter to a particular number, proceed as follows:
1.
Hold the
key depressed for approx. 2 seconds until the display changes to Counter: xxx.
2.
Depressing and holding one of the
and
keys starts the counter running. It runs to a
maximum of 999.
3.
Release the key when the desired number of packages to be sealed has been reached.
Signal tone power down
1.
Press
to switch off the signal tone for counting the seals.
2.
Press
to switch on the signal tone.
Resetting the daily batch counter
The daily batch counter counts the number of sealing procedures performed during a day. The daily batch
counter is displayed in the upper corner of the display: # 000.
In order to perform an update, proceed as follows:
Hold the
key depressed for a few seconds. The daily batch counter is then reset to #:000.
PLEASE NOTE
Switching the sealing device off and then on, also resets the daily batch counter. This does not
reset the total batch counter.
Summary of Contents for MELAseal Pro
Page 25: ......
