– This cordless screwdriver MAS36VLMU may only
be loaded with the charger RSS1002-044055-
W2E or in conjunction with the charging station
MAS36VLMUB. The charger may only be operated
on a power supply with an alternating current of
100-240V~ and a frequency of 50/60 Hz.
Any use of any other charger or the use of charger
type RSS1002-044055-W2E connected to a power
supply other than the one listed may lead to
personal injury and damages.
At purchasing, the battery of the cordless screw driver
is only slightly charged. For this reason, charge the
battery before using for the first time. When the LED
charge state display (2) shows weak battery power
(red lamp), charge the battery.
Recharging the battery (Figure 2)
The battery was not fully charged at the factory. The
battery must be charged before the unit can be used
for the first time. To do this, connect the charging
plug (10) of the power supply/charger (9) to the
charging connection (12) of the charging station (11).
Connect the power supply to a power source. The
red LED lamp of the charging station indicates that
the electrical connection has been established.
Insert the cordless screwdriver carefully into the
charging compartment (13) ensuring that the
charging contacts meet the charging connection of
the charging station. During the charging process,
the LED charging status display will be lit (2). The
end of the charging process is signalled by the light
changing to GREEN.
114
MW-5450080-Bedien-1903.indd 114
05.04.19 11:58