Meister i-drill MAS12ib 2.0, Translation Of The Original Instructions

Page: 74 / 208

74
Do not throw the battery
pack into water
Do not dispose of a battery
pack in the toilet
Do not throw the battery
pack into fire
7 – Charging battery
This MeisterCraft MAS 12ib 2.0
battery-powered screwdriver may
only be charged using the Typ 7101
mains adapter unit. The mains adapter
unit may only be operated with a power
supply that has an alternating current of
220-240 V~ and a frequency of 50 Hz.
The use of any other mains adapter
units or the use of the Typ 7101 with
another type of power supply may lead
to personal and property damage.
Lithium-ion battery technology
This new type of battery has decisive
advantages over conventional Ni-Cd
batteries:
• No memory effect, i.e. regardless of
its charge status the battery can be
recharged at any time before or after
use without loss of capacity.
• Extremely low self-discharge, so it is
ready for use even after longer storage
periods.
• Light in weight
• Long service life
Removing the battery pack (Figure 2)
Press the battery unlock button (12) and
pull the battery pack (5) out of the unit
Inserting the battery pack (Figure 2)
Press the battery unlock button (12) and
insert the battery pack (5) as far as it
will go into the unit. Release the battery
unlock button.
Charging process (Fig. 3)
Caution! The rechargeable
battery is not fully charged on
leaving the factory. Charge the
rechargeable battery before first use.
Caution! The working temperature
of the charger is 0 degree to
45 degrees.
Caution! When charge the
battery (5), please connect
the charging unit with power supply
first, then insert the battery into the
charging unit (6).
1 Connect the charging unit with power.
Wait until the green LED (7) lights up
and indicates a mains connection
(Fig. 1+4).
2 Insert the rechargeable battery into
the charging unit (8) (Fig. 3) The red
LED will light and the same time the
green one will be off.
3 The charging process will last approx.
60 minutes and be displayed by red
permanent lighting of the LED. It will
be ended when the red LED goes out
and the green LED lights up.
TIP! It is recommended
additionally to control the
charging process via an electrical
time-switch clock!
Caution! If the red or green LED
keeps flashing during charging
porcess for more than 30 minutes,
MC-5450520-Bediene-1308 02.08.13 08:23 Seite 74