WasteStar installation operating instructions FC
9670512
Design and construction subject to change without prior notice!
Page
25
of
40
9.2
Operation of the WTS-AK / AS / AM
•
The feeding station is switched on by pressing the white ON button. This is con-
firmed when the ON button lights up.
Switching on the feeding station starts a suction process. Further suction processes
are automatically started using set time intervals. The automatic suction processes
end when the black OFF key is pressed.
•
Put the collected organic kitchen and food waste into the funnel.
•
With the station switched on, pressing the white ON button starts suction be-
tween automatic suction processes.
•
The feeding station is switched off by pressing the black OFF button. The sys-
tem stops if the OFF button is pressed during the suction process.
Note 1!
The orange "release" light on the control panel means the system is ready for suc-
tion.
Note 2!
If the feeding is switch on, the white ON button flashes if there is an error. A fault
can be reset at this station by pressing the OFF button and then the ON button
again.
If the ON button continues to flash after the feeding station has been switched back
on again, contact building services immediately. Suction can be continued only af-
ter the fault has been rectified and the error message has been acknowledged on
the touch panel.
Note: Automatic suction process!
You can switch off the "Automatic suction" status. Every suction process must then
be started by pressing the ON button.
Note: Suction process not started!
If the funnel is not emptied by the suction process, one can start another suction
process with higher suction power by pressing the white ON button and holding it
for more than 2 seconds.
Summary of Contents for WasteStar FC
Page 40: ......
