Meggitt Fuelling Products
Maintenance Manual (MMF145)
Pressure Fuelling Nozzle
–
F145 Series
USE OR DISCLOSURE OF DATA ON THIS PAGE IS SUBJECT TO THE RESTRICTIONS ON THE TITLE PAGE OF THIS DOCUMENT
05 Jan 2015
Revision 6.4
16
DISASSEMBLY
1.
General
The following procedures describe the full disassembly of the F145 Series Pressure Fuelling nozzle.
2.
Disassembly Procedure
A.
F145
To disassemble the nozzle (see
IPL Figure 1
), do as follows:
1. (Mods: G1, H1, L1, N1, P, 3 thru 7) Remove screws (72), washers (73 and 74) and remove
valve assembly (70) or coupling assembly (81, 82) from adapter swivel assembly (71).
2. Remove screw (46) and O-ring (45). Discard O-ring (45).
3. At opening of screw (46) location; insert ball tool (T-90465) and rotate adapter swivel
assembly (71) until the tool captures all ball bearings (43).
4. (Mods: G1, H1, L1, N1, P, 3 thru 7) Remove adapter swivel assembly (71) from nozzle
body (1, 1A).
5. Disconnect dust cover assembly (53).
Note:
The dust cover assembly‟s cable is attached to the nozzle body (1
, 1A). To remove
the dust cover assembly; remove one bolt (48), washers (22 and 22A) and nut (23).
6. Remove spring (55).
7. Remove O-ring (6) and ball race (44). Discard O-ring (6).
8. (
Nozzle with TEO26383, or “Rev
R
” and subsequent revision letter
) Remove ball race (98).
