Megger BITE 3, Instruction Manual

Page: 18 / 42

M
AVTMBITE 3 Rev 8 April 2014
12
The flowchart of the menu structure:
Under Configure/Site-Strings/ Delete, it is not possible to delete a Site and/or
String until the data have been deleted first. This is to make sure that a
Site/String is not accidentally deleted. To delete data, go to System/Delete Tests
menu item. You will be asked “Are you sure?”
Measure
New Test
Select a String
(Test screen – starts with
temp (manual entry),
ripple current and float
current measurements
then goes into impedance,
voltage and strap testing
Discard measurement
Comments
Save and Close
Cancel and Close
Append to Test
Select a String
(Test screen – starts with
impedance, voltage and
strap testing. There is no
mechanism for float and
ripple current
measurements.)
Measure current
Measure impedance
Cancel and Close
Quick Test
Spectrum
Analyzer
Analyze
Analyze
Select a Test
Select and Continue
Close
Configure
Instrument
Instrument Name:
Auto Off: (time in seconds)
Line Frequency: (Hz)
Auto Measure: (0/1)
CT Mode: (Escape Current/
Impedance)
System Time: (y/m/d h:m)
Save and Close
Cancel and Close
Sites/Strings
Select a Site or String
New
Enter New Site information
Site:
String Name:
Baseline: (mOhms)
Warning: (%)
Fail: (%)
Change: (%)
Deviation: (%)
Save and New
Save and Close
Cancel and Close
Modify
Modify String Information
(same info as New)
Save and Close
Cancel and Close
Delete
Select a Site or String
Are you sure?
Close
Display
Temperature Units: (F/C)
Language
Date Format
Decimal Symbol: (./,)
Save and Close
Cancel and Close
System
Status
Battery Pack Voltage
Leadset:
Dual Point
AMP/Burndy
Quick Disconnect
Kelvin Clip
CT: none/standard
Close
About
Name:
Version:
Serial number:
Storage space: (%, # tests)
Battery Level: (%)
Current Date:
Close
Factory
(Enter password)
Delete Test
Select Test to Delete
(Are you sure?)