Megger BITE 3, Instruction Manual

Page: 11 / 42

AVTMBITE 3 Rev 8 April 2014
5
2
SAFETY
Overview
The BITE 3 and its recommended operating procedures have been designed
with careful attention to safety. However, it is not possible to eliminate all
hazards from electrical test equipment or to foresee every possible hazard that
may occur. The user not only must follow the safety precautions contained in
this manual, but also must carefully consider all safety aspects of the operation
before proceeding.
Any use of electricity inherently involves some degree of safety hazard. While
Megger has made every effort to reduce the hazard, the operator must assume
responsibility for his or her own safety. Any work on batteries is hazardous and
requires constant attention to safety. You should guard particularly against the
possibility of electrolyte spills, explosion, and electrical shock.
Safety Requirements
This instrument has been designed to the IEC 61010-1 safety standard. Observe
all industry standard safety rules for testing batteries.
 The BITE 3 is designed for connection to energized systems.
 Always disconnect optional lead sets from the battery under test.

The purpose of this instrument is limited to use as described in this manual.
Do not use the equipment or its accessories in an explosive atmosphere.
Explosive gases such as hydrogen can be present around batteries. Regardless
of room ventilation, verify the conditions before testing.

Wear protective clothing and eye protection.

Ensure that test leads and probes are in good condition

Observe all cautions and warnings in this manual and on the equipment.

This instrument is to be used only by suitably trained personnel who are
familiar with the hazards involved in testing high voltage dc systems.

Safety is the responsibility of the operator.