MegaTech Night Flyer, Flight Manual

Page: 6 / 16

6
CHARgINg YOUR NIgHT FLYER
1) Remove battery from airplane (Do NOT leave battery inside
the airplane while charging).
2) Make sure Transmitter is switched to the “OFF” position.
3) Plug the charging cord into the transmitter and battery and
battery as shown.
4) The Red LED will illuminate indicating the battery is being
charged. The LED will turn off in approximately 10 minutes
indicating that the charging is complete.
INSTALLINg YOUR FLIgHT PACk
1) Unlock and remove the battery hatch
on the bottom of the fuselage.
2) Attach the battery connector to the connector inside the
fuselage.
3) Place the battery into the fuselage with the wide section of
the battery going in first.
4) Attach the battery hatch and move the latch back to the
locked position.
NOTE: Plane lights will illuminate when flight pack is plugged into the plane regardless of the “ON/
OFF” switch position.
CYCLINg BATTERY PACk
1) Charge the battery pack as shown above.
2) Make sure airplane & transmitter are switched to ‘OFF’ and connect battery to
airplane.
3) Securely hold the airplane’s fuselage. Be sure the propeller is away from you and any
loose clothing or jewelry.
4) Turn the transmitter to the ‘ON’ position then switch the plane to the ‘ON’ position.
5) Push the left hand stick of the transmitter (the throttle stick) completely forward
until the battery runs out.
6) Allow battery to cool COMPLETELY.
7) Recharge the battery and repeat process 2 more times.
NOTE: FOR PEAk PERFORMANCE AND OPTIMUM FLIGHT DURATION, IT IS IMPORTANT TO CYCLE THE
RECHARGEABLE FLIGHT BATTERY PACk 3 TIMES BEFORE FLYING. CYCLING IS ONLY REqUIRED FOR THE
INITIAL FLIGHT.
LOCk
UNLOCk
Transmitter
Battery
Charger
Cord
ATTENTION PARENTS: The charging system, charging wire, battery flight pack, and all electrical
connections need to be periodically examined for potential conditions that may result in the risk of
fire, electrical shock, or injury to persons. In the event of such condition, the hazardous parts should
not be used until properly repaired or replaced.