MegaTech Night Flyer, Flight Manual

Page: 5 / 16

5
ATTACHING LANDING GEAR
1) Squeeze wheels together
2) Continue holding wheels together and insert landing
gear into slot on bottom of fuselage behind the battery
hatch.
3) Release the wheels and gently spread apart
INSTALLINg THE BATTERIES
Transmitter requires 8 “AA” 1.5V Alkaline batteries (sold seperately).
Remove the battery compartment cover located 1)
on the back of the transmitter by sliding it down.
Insert 8 “AA” 1.5V Alkaline batteries. Be sure
2)
to match the ‘+’ and ‘-’ polarity symbols in the
transmitter with each battery.
Replace battery compartment cover. 3)
Locate the transmitter antenna, insert and screw 4)
into the top of the transmitter clockwise.
Turn the transmitter ‘Power’ switch to the ‘ON’
5)
position. The red and green LED lights will
illuminate.
IMPORTANT: Be sure not to over tighten antenna.
NOTE: If the LED’S do NOT illuminate, do NOT attempt to fly
your Night Flyer. Make sure you are using all fresh alkaline
batteries and check the batteries for correct polarity
placement. If the LED still fails to illuminate, contact
Megatech support at 1-888-634-2911.
CAUTION
READ THIS SECTION BEFORE CHARGING
YOUR BATTERY PACK FOR THE FIRST TIME!
• Always monitor the charging process.
•
Remember to unplug the battery from the charger when completely charged.
• Always allow the battery to cool completely before charging or discharging.
FAILURE TO DO
SO MAY CAUSE PERMANENT DAMAGE TO THE BATTERY AND POSSIBLE BODILY HARM.
• Never leave the model unattended while charging.
• Do not charge battery more than 10 minutes. Charging longer may damage the battery
+ + + +
+ + + +
- - - -
- - - -
Twist
to
Attatch