ENGLISH
ENGLISH
18
19
Installation and Operation
Installation and Operation
In the menu LNB frequency, you can make the settings for one-cable-systems (Unicable).
By using the b/-, you can select different settings for the LNB. The set-top box
can be programmed for different Unicable systems. Depending on the system can be
connected to a system up to 8 set-top boxes.
Unicable (9750-10600) is pre-programmed for all identical systems by Kathrein, Technisat
and Megasat
IF Channel/Center Freq.: 1=1284; 2=1400; 3=1516; 4=1632;
5=1748; 6=1864; 7=1980; 8=2096
Inverto and identical systems use the following.
IF Channel/Center Freq.: 1=1076; 2=1178; 3=1280; 4=1382;
5=1484; 6=1586; 7=1688; 8=1790:
Check the appropriate one for your system frequencies.
At IF Channel You can select up to 8 different frequencies, it is automatically associated
with each IF channel frequency. Note that each frequency may be present only once in
your system. The frequencies depend on your cable system and can not be changed
arbitrarily.
For systems that do not match the pre-programmed center frequencys, you can adjust
it by pressing the red button.
WARNING:
The center frequency must always comply with the center point. Example:
The frequency 1284 at port1 should not be placed on port2. The appropriate frequencies
and ports can be found in the description of your UniCable system.
Basically, we use the lowest frequency for the longest cable to the set-top box.
Single Satellite Search
1. Satellite:
Select with the +/- buttons the
satellite and press the OK button and se-
lect the satellite from the list, then press
the OK button.
2. Nur für FTA:
select by pressing the but-
tons +/- YES or NO.
3. Channel search:
select with the +/- but-
tons the channel type:
TV + radio, TV or radio.
4. Network Search:
select YES or NO. If
the auto tuning is selected, this option is
marked as not active (it remains gray).
5. Search Mode:
select by pressing the
+/- buttons between the „blind scan“ (all
available services of the selected satellite
will scan) or „Present Search“ (will scan
only the transponders, which are listed in
the transponder list).
6. Search:
Press the OK / List button to start
the search.
Multi Satellite Search
At the Multi satellite search all satellites that have been selected in the submenu „satelli-
te list“ to be searched. Proceed to the next steps as with the single satellite search.
Unicable System
Satellite Search