Megalarm MEGA 3600, Installation Manual

Page: 17 / 25

Press
T
ransmitte
r
Button
One Chirp /
LED one pulse
Factory Default
Setting
Two Chirps /
LED two pulses Three Chirps /
LED three pulses
Four Chirps /
LED four pulses
1
Override Without
Password Pin Code Override With
Password Pin Code
2
H8/8 Pink Wire =
Two step door
unlock output H8/8 Pink Wire =
Factory Security
Disarm Signal
Output H8/8 Pink Wire =
Start Status Output
(Shock Sensor
Bypass)
3
4
H8/3 Brown / White
Wire = (-) 200ma
Horn Output H8/3 Brown / White
Wire = Factory
Security Rearm
Signal Output
H8/6 Black / Green
Wire Channel 4 H8/6 Black / Green
Wire Channel 4 H8/6 Black / Green
Wire Channel 4 H8/6 Black / Green
Wire Channel 4
Output =
Momentary output
Output =
Latched output Output =
Latched output and
reset with ignition
“on” Output =
Timer programming
(set to any interval
between 1 second
and 2 minutes.)
+
5
Five Chirps / H8/6 Black / Green Wire = Key Sensor By-Pass Output (20second
Ground output during the remote start is activated)
LED five pulse
H8/5 Black / Red
Wire Channel 5
Output = H8/5 Black / Red
Wire Channel 5
Output = H8/5 Black / Red
Wire Channel 5
Output = H8/5 Black / Red
Wire Channel 5
Output =
+
6
Timer programming
(set to any interval
between 1 second
and 2 minutes.) Latched output and
reset with ignition
“on” Latched output Momentary output
H8/2 Black / Violet
Wire Channel 6
Output = H8/2 Black / Violet
Wire Channel 6
Output = H8/2 Black / Violet
Wire Channel 6
Output = H8/2 Black / Violet
Wire Channel 6
Output =
7
+
Timer programming
(set to any interval
between 1 second
and 2 minutes.) Latched output and
reset with ignition
“on” Latched output Momentary output
Exit
: Turn Ignition to 'ON' position, or leave it for 15 seconds. A 3 long chirps & 3 parking light flashes to
confirm exit.
Channel 4 (5 / 6) Timer Control Output Programming.
Enter:
1. Turn the Ignition 'switch ‘ON/OFF’ 3 TIMES and stay in OFF position.
2. Push the Valet switch 6 times and hold it until
three chirps with a long chirp is hearing then release the
valet switch. You are now in the Alarm feature ‘III’ programming mode.
Timer Program:
+
button 4 times, [4] LED flash, [4] siren/horn chirp to indicate 1-a. Press and release the transmitter
your are in features “Channel 4 Timer Programming mode”.
+
button 4 times, [4] LED flash, [4] siren/horn chirp to indicate 1-b. Press and release the transmitter
your are in features “Channel 5 Timer Programming mode”.
1-c. Press and release the transmitter
+
button 4 times, [4] LED flash, [4] siren/horn chirp to
indicate
your are in features “Channel 6 Timer Programming mode”.
2. Press and hold the valet switch, the timer will immediately start.
17