DMX-512 Addressing
1 2 3 4 5 6 7 8 9 10
ON
D
M
X ON
256
12
8
64
32
16
8
4
2
1
To address the unit each dipswitch from one to 9 hold a nu-
merical value located on the below the image. You will have to
add the numerical value to give you the correct fixture start
address. The user must assign a start address on the fixture
that indicates the first channel reserved in the controller.
For example if you wish the first unit to start on address chan-
nel 85 you will need to turn on dipswitch 1,3,5 and 7
(1+4+16+64=85)
The Cobra 1500 uses only one DMX Channel for output volume.
For DMX mode set dipswitch 10 to the on position
A blue LED flashing will indicate DMX signal is receiving.
Warm Up Time
There is a approximate 7 to 8 min warm up time for the heat element to be ready.
The Cobra 1500 will indicate that the unit is ready to start to produce fog. When the red LED in the tank storage is off and the
green LED is turned on.
Caution!
1.
Do not run the fogger when there is no fog liquid in the storage tank. This may dam
age the liquid pump.
2.
Only use Mega-Fog fog fluid liquid.
6
Wire Remote Control
Wireless Remote Control
1. Connect on/off Wire Remote Controller to Control input on back of machine
2. Switch on power. Red LED next to tank is on when Machine is warming up.
3. When Red LED turns off and the Green LED turns on next to holding tank machine
is ready to fog
4. Press fog button on remote to fog
1. Connect Wireless Receive to Control input on back of machine
2. Switch on power. Red LED next to tank is on when Machine is warming up.
3. When Red LED turns off and the Green LED turns on next to holding tank machine
is ready to fog
4. Press any button on wireless remote to fog
