ENGLISH
58
Replacing the batteries in the laser unit
(fig. 17)
WARNING:
Switch off the tool and unplug the power
cord before performing maintenance and making
adjustments and before changing the saw blade.
Set the saw blade in its highest position.
Remove the saw blade guard (6).
Loosen both the two screws (11), turn the
protection plates to the side and remove the
laser unit's battery cover. Remove both
batteries.
Insert new batteries of the same type. Insert
with the same polarity as the old batteries.
Replace the battery cover.
Check the direction of the laser beam and
adjust if necessary.
Replace the saw blade guard.
Cleaving wide workpieces
Workpieces wider than 120 mm
Tools: Cleaving blade.
Method: Adjust the parallel fence according to the
width of the workpiece. Keep your hands away from
moving parts. Advance the workpiece with your right
hand or the feeder. Always use the feeder if narrow
parts are being sawn off the workpiece. Move the
fence backwards to the middle of the saw bench or
use a short auxiliary fence if there is a risk of the
workpiece becoming trapped between the saw blade,
the splitting knife and the fence.
For the sake of clarity, the dust extraction cover is
either not shown or only the upper dust extraction
cover is shown in the figures on page 26–28.
Note:
The upper dust extraction cover must always be
installed when the tool is used.
Cleaving narrow workpieces
Workpieces narrower than 120 mm.
Tools: Cleaving blade.
Method: Adjust the parallel fence according to the
width of the workpiece. Advance the workpiece with
both hands. Use the feeder near the saw blade.
Advance the workpiece until it has passed the splitting
knife. Always use the feeder for short workpieces.
Summary of Contents for 278-445
Page 61: ......
