EN
54
POWER SWITCH
NOTE:
• Prolonged use at a low speed increases the risk of the motor overheating. Avoid overheating by
switching off the drill driver for 15 minutes at regular intervals to cool the motor.
• Always hold the machine firmly with both hands.
1.
Start the drill driver by pressing the power switch.
– Press the power switch harder to increase the speed.
– Release the pressure on the power switch to reduce the speed.
2.
Release the power switch after drilling to switch off the drill driver. Wait until all moving parts
have completely stopped before putting down the drill driver.
SCREWING
NOTE:
• We recommend predrilling a hole slightly longer with a smaller diameter than the screw to be
screwed in. The predrilled hole helps the screw to come right, and makes it easier to screw in. A
predrilled hole will prevent the wood breaking when drilling near the edge of a workpiece.
• Use the correct countersink drill to properly sink the screw head, so that it does not stick up from
the surface.
• If it is difficult to get the screw in, remove the screw and try with a slightly larger or longer hole.
Note that there must be enough material to grip the screw.
• If you start again with a screw in a hole, insert the screw and screw the first few turns by hand. If
it is still difficult to screw it in (e.g. very hard wood) you can try using a lubricant. Liquid soap
usually works best.
Power switch with speed control
Summary of Contents for 060-201
Page 57: ......
