EN
48
Service
• The drill driver must only be serviced by qualified service personnel using
identical spare parts. This will ensure that the drill driver remains safe to use.
• Only use LI-Ion batteries.
Special safety instructions for drilling
• Wear ear protection. Exposure to loud noise can cause hearing impairments.
• Use the support handle, if the drill driver is supplied with one. Otherwise, you
could lose control of the drill driver and become injured.
• Hold the drill driver by the insulated grip when working in areas where the bit can
come into contact with concealed cables. Contact with a live cable will cause the
metal parts on the driver to also become live and give the user an electric shock.
Special safety instructions for screw driving
• Hold the drill driver by the insulated grip when working in areas where the bit can
come into contact with concealed cables. Contact with a live cable will cause the
metal parts on the driver to also become live and give the user an electric shock.
Special safety instructions for the battery and charger
• Under extreme conditions, acid can leak from the battery. Avoid contact with
battery acid. Rinse well with plenty of water if you come into contact with
battery acid. Seek medical attention if you get battery acid in your eyes.
• Check that the mains voltage corresponds to the rated voltage on the type plate.
• Do not charge the battery in the rain or in damp or wet areas.
• The ambient temperature must not exceed 40°C. Do not expose the unit
to direct sunlight.
• Batteries that are defective or damaged, or that cannot be charged, must be
disposed of in accordance with local regulations. A damaged power cord must be
replaced by an authorised service centre, or qualified person, to ensure safe use.
Repairs must only be carried out by qualified personnel.
• Only use batteries recommended by the manufacturer.
• Keep the surface of the charger free from dust and dirt.
• Insert the battery in the charger with the battery terminals facing in the right direction.
• Always remove the battery before doing any work on the drill driver.
• Cover the battery terminals when the battery is not in the drill driver, in order to
avoid a short-circuit.
Summary of Contents for 060-201
Page 57: ......
