SE
37
9
Handle
10
Spindle lock
11
Collet
12
Bit
NOTE
• The 8 mm collet is fitting in the spindle on delivery The transparent cover over the dust
extraction mechanism can be removed to simplify changing collets or bits Remove the cover by
removing the two clamping screws underneath the baseplate
• You only need to slightly release the clamp nut to replace bits with the same shank diameter It is
not necessary to completely remove the clamp nut
WARNING!
• Handle bits with care – risk of cutting yourself Only use accessories that can withstand with the
maximum speed of the tool (see technical data)
• Clean the chuck, collet and bit before fitting
• Check that the bit and chuck are correctly fitted and rotate freely before starting the tool
CONNECTION OF VACUUM CLEANER
• You can connect a vacuum cleaner to the dust extraction mechanism on the tool
• The outer diameter of the dust extraction connection is approx 38 mm, and the inner diameter
is approx 34 mm Always use a dust extraction system to ensure a safe and clean working
environment
Handle
Screw tight the handles in the threaded holes on the sides of the tool
USING A MACHINING TEMPLATE
The round metal template guide is used to move the tool along the required contour The template
guide bush, which has an external diameter of 19 mm, must fit to the template The template contour
is transferred to the workpiece Follow the instructions below to fit the template guide
1
Place the tool on a flat, non-slip surface
2
Fit the required bit
3
Remove the two clamping screws from the dust extraction mechanism underneath the
baseplate
4
Fit the template guide with the bush facing downwards
5
Fix the template guide with the clamping screws and the dust extraction mechanism (see
diagram)
Summary of Contents for 040-026
Page 41: ......
