SE
34
unless they are familiar with these instructions Power tools are dangerous if used by
inexperienced people
• Keep the power tool properly maintained Make sure that moving parts are properly adjusted
and do not jam and that no parts are incorrectly fitted or damaged Check for any other factors
that could influence functionality If the power tool is damaged, it must be repaired before being
used again Many accidents are caused by poorly maintained power tools
• Keep cutting tools sharp and clean for better, safer work Properly maintained cutting tools with
sharp cutting edges are less likely to jam and are easier to control
• Use power tools, accessories, bits, etc, in accordance with these instructions, taking into account
actual working conditions and the work that is to be done Use the power tool only for its
intended purpose
WARNING
• Follow the safety instructions when working with power tools to safeguard against the risk of fire,
electric shock and personal injury
• Wear safety glasses Wear a dust filter mask Wear ear protection
• Secure the workpiece with a clamp, vice or clips
• Never use router bits that are warped, deformed or damaged in some other way Only use bits
with a shank diameter of 6 or 8 mm, which can withstand the maximum speed of the tool
• Never use blunt bits
• Only use bits intended for wood and other similar materials
• Make sure the workpiece is free of nails and foreign objects
• Allow the motor to reach full speed before milling Never start the tool when the bit is in contact
with the workpiece
• Do not press the tool forwards too hard Smooth forward movements reduce the risk of problems
and will ensure the tool lasts longer
• For best results, work anticlockwise when working with outer contours and clockwise when
working with inner contours
• Machine in several stages when using large diameter bits, or when machining a lot of material
• Switch off and unplug the tool immediately in the event of abnormal noise or abnormal
vibrations
• Do not put the tool down until it has completely stopped
• Switch off the tool, unplug the power cord and wait until all moving parts have stopped
completely before carrying out any cleaning and/or maintenance Unplug the power cord when
the tool is not in use
• Switch off the tool, unplug the power cord and wait until all moving parts have stopped
completely before attempting to remove cuttings or bits etc
• The tool is only intended for machining wood and other similar materials
Summary of Contents for 040-026
Page 41: ......
