Meec tools 009461, Operating Instructions Manual

Page: 55 / 61

EN
41
open the metal ring at the opening.
When the metal ring returns to its original
shape the chippings bag is firmly fixed.
4. The clamping device (8) can be mounted
to the left or right side of the fixed saw
table (18).
5. Fit the transport handle (43) with the two
screws (46).
NOTE:
• Phillips screwdriver sold separately.
• The hex key 6 mm (45) to replace the
the saw blade should be stored on the
back of the machine.
ADJUST THE SAWING/METRE
ANGLE (DIAGRAMS 1-3, 7)
1. To set the rotational saw table (19) the
lock lever (20) should be in its raised
position. Only then can the saw table be
adjusted when pushing in the interlock
button (21).
2. Turn the saw table (19) and the pointer
(22) to the intended angle on the scale
(23).
– The saw has locking positions at
-45°, -30°, -22.5°, -15°, 0°, 15°,
22.5°, 30° and 45°. In these
positions the saw table (19) will click
in place. A soon as the table has
clicked in place it must be fixed by
pushing down the lock lever (20).
3. If other angles need to be set the table
(19) can only be fixed with the lock lever
(20).
4. Gently press down the machine head (4)
and pull out the safety pin (30) from the
motor bracket to lock the saw in relation
to the bottom position.
5. Swing up the machine head (4).
6. To set the machine head (4) for mitre
29. Fixing screw for slide control
30. Safety pin
31. Screw handle to limit sawing depth
32. Check nut to limit sawing depth
33. Stop plate to limit sawing depth
34. Screw to limit sawing depth
35. Adjusting screw for angle stop 90°
36. Adjusting screw for angle stop 45° left
37. Check nut for angle stop
38. Flange screw
39. Outer flange
40. Spacer
41. Laser
42. Power switch for laser
43. Transport handle
44. Adjusting screw for fence
45. Hex key, 6 mm
46. Screw for transport handle
47. Adjusting screw for angle stop 45° right
48. Removable fence
49. Set screw
ASSEMBLY
ASSSEMBLE THE SAW
(DIAGRAMS 1-6)
1. Put both saw supports (10) in the holes
on the side of the fixed saw table (18).
Fix the saw supports (10) with the screws
(12). This works as an an end stop. Use a
Phillips screwdriver.
2. The saw support (10) can be moved,
depending on the length of the workpiece
to be sawn. After putting the saw support
(10) in the right position the setting can
be fixed with the ratchet handle (11).
3. The chippings bag (27) is fixed on the
outlet opening (28) on the saw by pulling