SPECIAL DIMENSIONS OPENING INWARDS (Fig. 2, page 5)
We are occasionally forced to vary the standard dimensions for reasons of space when placing the supports, the above graphs refer to the both
automatic gate mechanism models (240-360) and when the opening is inwards.
The gates' opening degrees are shown at the top of each of the graphs, from these values a cross section line emerges on which dimensions A
and B may be obtained (Fig. 2, page 5). It is important to be as close to the thick vertical line as possible.
Dimension C remain constant in both motors, model 360 C=90 mm and model 240 C=70 mm.
Example
: What would be the dimension A and what engine should I use to automate a gate with a 100° opening where B=140 mm? A motor
with a 360 mm stroke length and dimension A=195 mm (see example in graph of assembly dimensions 360 with thick discontinuous line,
special dimension).
Conclusion:
We cannot choose model 240 because it goes beyond the positioning limits. The 360 mm stroke length motor allows higher
dimensions than the standard.
6 of 11
ASSEMBL
Y DIMENSIONS 240 (C=70)
ASSEMBL
Y DIMENSIONS
360 (C=90)
*Measurements in millimetres.
EXAMPLE (STANDARD)
EXAMPLE (SPECIAL DIMENSION)
