Medit Identica hybrid, User Manual, Page: 32 / 129

31
Using Identica Hybrid
If scanning an antagonist, you must select at least one tooth on the other side of the arch as an “ antagonist. ”
3. Select whether there is a bridge or not with the connector between selected restorations
By default the bridge is created to adjacent restorations with the pontic.
-
Taupe
: There is a bridge.
- Gray : There is no bridge. (If you need a bridge, click connection points)
-
If there are no connectors
: In case the selected restoration does not have a bridge.
4. Leave a note about dentists/patients/workers in the notes section
1
Save and scan
Complete the work information, and click " Save " on
2
. All the work and information will be added to the database
and a folder will be created. All the work and related information will be saved into a folder.
Once the work is saved, the
‘ Scan ’ button will be activated. You can start scanning if click ‘ Scan ’
3
.
The activation of the icon and its function can be different depending on the work type.
Multi-die configuration screen
If you click the multi-die button
1
, you will see the following image.
Button setup
2
Configure multi-die setup
To proceed with the scan, select the desired position of the teeth from 1-8. Setup the selected restoration.
3
Job setup configuration
Tooth type Crown/Coping
Offset Coping : Setup for a simple coping with a fixed thickness over the preparation.
Tooth type Inlay / Veneer
Offset Inlay : Setup for a simple inlay with a fixed thickness over the inlay preparation.
2
1
3