Medion The Touch X9613, User Manual

Page: 51 / 106

Saf
e
ty
Connecting
Operation
Help
Appendix
USB Port
- 45 -
USB Port
Note
Devices connected directly to the USB bus should not draw more than 500
mA. The voltage output is protected by a fuse (Limited Power Source ac-
cording to EN 60950). Should the devices need more power than this, it will
be necessary to provide a hub (distributor / booster).
On the USB it is possible to connect up to 127 devices which correspond to the USB stan-
dard (1.1 and 2.0 supported).
The data transfer speed is 1.5 Mbit/s or 12 Mbit/s, depending on the device connected.
USB 2.0 can reach up to 480 Mbit/s.
Note
If possible, always connect your USB devices to the same port where it has
been installed. Otherwise you will get a new ID and your operating system
will ask for a new installation of the driver.
eSATA port
eSATA stands for " e xternal S erial ATA " and is used for connecting external hard disks.
Unlike common USB standards, the transmission speed of an eSATA connection is higher
than that of external USB hard disks.
Remove S-ATA devices
Before removing an S-ATA hard disk from your All-In-One PC, click on the icon " Safely
remove hardware " in the task bar and then on the hard disk to be removed.